Biamp Tesira Update

Tesira 5.7 is now available to download and enables support for Workplace Control on TesiraFORTÉ X processors. In addition to bug fixes and security updates, Tesira Software now loads up to 40% faster. Read the complete Tesira release notes on Cornerstone for all the details.

New Features:

Added support for Biamp Workplace Control on TesiraFORTÉ X series processors. Workplace Control provides a powerful new control engine hosted on Tesira DSPs, including visual event driven design, Lua control scripting, and hosting Apprimo touch panels.

Updates:

Reduced Tesira Software startup time by up to 40%.

Resolved Software Issues:

Resolved issue where undo/redo on a Custom block could cause invalid ports and connections to persist.

Resolved issue where Custom blocks could not be set below 230 pixels wide.

Resolved issue where meters would appear above an expanded Custom block.

Resolved issue where Parlé TTM-X Microphones with locked beams could not set beam elevation to 7.5 degrees when a beam was aimed at 7.5 degrees in the Azimuth.

Resolved Firmware Issues:

Resolved issue with Tesira devices operating with a Workplace Bridge reported wrong IP address when in single cable mode.

Resolved issue with TesiraFORTÉ DAN (Rev A.) updating to 5.4.1 and newer causing failure to communicate with IO card in slot 1 fault.

Resolved issue with TesiraFORTÉ X USB output level was not synching with the host level control on macOS.

Resolved issue with Voltera amplifiers becoming unresponsive when proxying more than 10 NPX paging stations.

Resolved CVE related to SSH by updating OpenSSH to 10.3p1.

Download Page is here